Run calculation
1.Select Analyzer > Long term planning > Calculation.
2.Select the Scenario case.
3.Define Start year and End year.
4.Press Start calculation. The system processes all assumptions in the selected scenario case.
Review results
1.Select Analyzer > Long term planning > Results.
2.Right-click a calculation and select See reports.
3.Review the results as charts or tables.
4.Apply filters if needed, for example year range or scenario level.
5.Press 
to export results if required.
|
If a calculation contains errors or does not produce the expected result, you can view the calculation log. The log is displayed directly at the time of the calculation, but can also be opened afterwards. 1.Right-click on a calculation in the results list and select See calculation log. The log contains information, warnings and errors that occurred during the calculation. |
View results in attribute form
|
To view the LTP calculation results tab in attribute forms, the LTP_USER role is required. Only approved calculations are displayed. See section Approve calculations below. |
Results from calculations can also be displayed directly in attribute forms for relevant network objects.
1.In the attribute form of the desired object, select the LTP calculation results tab.
2.Right-click on a calculation and select See reports to view the results of calculations associated with the selected object.
Approve calculations
|
To change the status of calculations, the LTP_ADMIN role is required. |
Each calculation has a status that controls whether the result is available to other users.
The following statuses exist:
•Pending - Default state after a calculation has been run.
•Approved - The calculation is approved and can be used by others.
•Disapproved - The calculation should not be used.
To change the status:
1.Select Analyzer > Long term planning > Results.
2.Right-click on a calculation and select Approve calculation or Disapprove calculation. When a calculation is approved, the results become available to other users in the attribute form for the affected objects, LTP calculation results tab.