1 Production distribution

Here there is an opportunity to selectively affect a generator production and to disconnect a specific type of generator.

The production will be reduced to the desired production percentage according to specified values. Both the active power and the reactive power will be recalculated.

If 0 % is set, all generators of that specific type will be excluded from the calculation, both in terms of loads and fault current.

 

The production types that can be seen in the calculation dialog depends on the types that exists in the codelist: FPP.ELREGTYPE_CL. In the codelist there is also an opportunity to set default values for the percentage that should be used in the calculation.

 

2 Production

If the check box Include production is checked, the production will be included in the calculation. It is also possible to set the production distribution for solar panel and windpower.

If the calculation is a symmetrical calculation, the production will be distributed on the three phases even if it is documented as a single phase.