The Distribution point part overview shows an overview for copper cables connected to distributions points in nodes. The overview displays the ID, type, and length of the copper cable, as well as the selected start and end nodes and any distribution nodes in between.
Generate a copper cable overview
1.In the menu bar, select Reports > Distribution point part overview.
2.Select a copper cable in the map. The Cable overview dialog opens.
|
The Distance column in the Cable overview dialog, refers to the number of nodes along the route in which the cable is spliced/connected. If the distance is "0", it means that the selected cable runs undivided to the node. |
3.Select a start node in the table on the left. Valid end nodes are shown in the table to the right.
4.Select an end node in the right list.
5.In the drop-down menu, select your preferred Layout.
oTree, straight main route - The nodes along the main road are drawn in a straight horizontal line. Any branches are drawn in vertical lines.
oTree, folded main route - The main road is folded when necessary. Any branches are drawn horizontally or vertically.
6.Press OK. The cable overview opens in a new window.