|
<< Click to Display Table of Contents >> dpPower > Menu reference > Show > Command field |
Opens a command field where a set of system commands can be entered. Accepted command entries are temporarily stored and can be recalled with the up arrow key and down arrow key.
1.Select Show > Command field. The command field opens.
2.Select command from the list.
3.Select component in graphics view.
4.Press Run.
Coordinate indication |
For example, when zooming. ne=north,east where north is the north coordinate and east is the east coordinate. xy=math x,math y Note! this indication is in the mathematical coordinate system. Example: ne=6980486,1516983 |
View rotation |
Rotates the view. vr=angle in degrees Example: vr=20 |
Buffer zone |
Creates a buffer zone around any component. bz=width in meters Example: bz=10. Then select a component in the graphical view. A buffer zone is created around the component. Select Refresh (F5) to remove the buffer zone. |
Grid |
Shows grid. gr=distance in meters Example: gr=10 |
Delta displacement |
For example, when moving component. Can be used in combination with snapping. The result is then a specified point: [snap point + dx=x,y] dx=delta x math, delta y math Example: dx=30.20 |
Angle indication |
For example, when turning component. aa=angle value in degrees Example: aa=25 |